Browsing by Author Ramamurti, V.

Jump to: 0-9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
or enter first few letters:  
Showing results 1 to 20 of 82  next >
Issue DateTitleAuthor(s)
1981A parametric study of vibration of rotating pre-twisted and tapered low aspect ratio cantilever platesSreenivasamurthy, S.; Ramamurti, V.
1980Acceptance Curve for Overhead Line Damper EvaluationSathikh,S.; Ramamurti, V.; Chari, R.T.
1987An equation solver for eigenvalue problems of cyclic symmetric structuresBalasubramanian, P.; Ramamurti, V.
2002An incremental approach for large displacement response of structures subjected to dynamic loadsRamamurti, V.; Rajarajan, S.; Rao, G.V.
2000Analysis of active damping in composite laminate cylindrical shells of revolution with skewed PVDF sensors/actuatorsSaravanan, C.; Ganesan, N.; Ramamurti, V.
2007Analysis of industrial steam turbine blades using cyclic symmetrySujatha, C.; Ramamurti, V.; Bhat, M.M.
1973Application of simultaneous iteration method to torsional vibration problemsRamamurti, V.
1970Asymmetric bending of cylindrical conical shell junctionAlwar, R.S.; Ramamurti, V.
1989Automatic mesh generation in 2-D and 3-D objectsNagesh, K.; Srikant, A.; Ramamurti, V.
1980Bending of an annular plate in the presence of a concentrated, in-plane edge loadSrinivasan, V.; Ramamurti, V.
2000Boat tail effect of a payload fairing on the elastic displacement responseRamamurti, V.; Rajarajan, S.; Rao, G.V.
1973Comparison of elasticity theory and shell theory solutionsRamamurti, V.; Alwar, R.S.
1995Comparison of semi analytic and cyclic symmetric approachesRamamurti, V.
1997Computer-aided design of a two-stage gearboxRamamurti, V.; Gautam, P.; Kothari, A.
2002Contribution to the design of heavy duty girth gear for transmitting large outputs [Beitrag zur auslegung von schweren zahnkr�nzen f�r die �bertragung gro�er leistungen]Jayaraman, N.P.; Raghavan, M.; Ramamurti, V.
1990Coupled free vibration characteristics of rotating tuned bladed disk systemsOmprakash, V.; Ramamurti, V.
1992Design aspects and parametric study of 3-roll heavy-duty plate-bending machinesRamamurti, V.; Rao, V.R.S.; Sriram, N.S.
1996Design considerations of over-crank and under-crank guillotine shears: A comparative studyRamamurti, V.; Gowri, S.
2007Design guidance for cordon shaft of twin drives in cement mills [Konstruktionsanleitung f�r die Kardanwelle von Zwillingsantrieben von Zementm�hlen]Ramamurti, V.; Mohan, M.; Ganapathi, J.
2007Design guidance for cordon shaft of twin drives in cement mills [Konstruktionsanleitung f�r die Kardanwelle von Zwillingsantrieben von Zementm�hlen]Ramamurti, V.; Mohan, M.; Ganapathi, J.