Shunmugam M S

High-aspect-ratio high-quality microholes are required in turbine blades to improve cooling performance. These cooling holes are drilled by pulsed laser and hence dimensional as well as geometrical tolerances like circularity and cylindricity are important. The measurement of geometrical features of the microholes is a very challenging task without destroying the components. In the present work, the microholes are produced on Ti6Al4V alloy by ultra-short pulse laser. The geometrical features of microholes are then captured using a non-destructive technique, namely computed tomography. CT-scanned 3D data is directly used for geometrical analysis using open-source software, GOM Inspect. Since algorithms used in the GOM Inspect are proprietary in nature, the extracted coordinate data are also analyzed using the computational methods developed by the authors based on least squares technique. The dimension, circularity, and cylindricity of microholes are compared with the results obtained from GOM Inspect software and a close match is found.