Options
Ravi Sankar Kottada
Loading...
Preferred name
Ravi Sankar Kottada
Official Name
Ravi Sankar Kottada
Alternative Name
Kottada, Ravi Sankar
Kottada, Ravi S.
Ravi Sankar Kottada, Praveen S.
Kottada, R. S.
Main Affiliation
ORCID
Scopus Author ID
Researcher ID
Google Scholar ID
2 results
Now showing 1 - 2 of 2
- PublicationVerification of correlation between densification during spark plasma sintering and compressive creep of ultrafine-grained in-situ Al2O3-reinforced B2 aluminide matrix composites(25-02-2018)
;Chawake, Niraj ;Koundinya, N. T.B.N.The B2-Aluminide matrix (FeAl and NiAl) with in-situ Al2O3 reinforcement were synthesized using reactive milling. The oxides (Fe2O3 and NiO) were reduced by Al during high energy milling to form Al2O3. The 20 h ball milled powders were consolidated using spark plasma sintering (SPS). To understand the densification mechanisms during SPS, sintering was performed at various temperatures (750–850 °C) and applied pressures (25–100 MPa). The creep parameters are evaluated from the densification data obtained during SPS using the model proposed by Bernard and Granger. In addition, independent constant-stress compression creep studies were conducted on the dense SPS pellets. The creep studies were performed on the composites at 800 °C at different stresses (100–500 MPa). The densification studies and compression creep studies are correlated based on the creep parameters obtained from both these studies and corroborated by TEM studies of the crept samples. This correlation is found to be valid even for the in-situ composites. Thus, the analysis of densification data can be helpful in predicting the creep behavior and useful for designing the new creep resistant alloys or composites. - PublicationAn investigation on diffusivity while achieving a cylindrical aluminide coating on metals using simultaneous spark plasma sintering of powders(01-09-2019)
;Chawake, Niraj ;Ghosh, Pradipta ;Eckert, JürgenSimultaneous spark plasma sintering (SPS) of metal powders (Fe and Ni) with their respective aluminide powders (FeAl and NiAl) was attempted to produce a cylindrical aluminide coating on a cylindrical metal core. The interdiffusion zone (IDZ) formed between the metal and the aluminide was analyzed to evaluate the diffusion coefficient. The composition variation and the actual temperature estimated at the interface were taken into consideration while evaluating the diffusion coefficient. The diffusion coefficients estimated based on the IDZ are found to be higher than those obtained by conventional methods but are in agreement with those obtained from previous SPS studies.