Behaviour of lightweight expanded polystyrene concrete containing silica fume

Lightweight concrete can be produced by replacing the normal aggregate with lightweight aggregate, either partially or fully, depending upon the requirements of density and strength. The present study covers the use of expanded polystyrene (EPS) beads as lightweight aggregate both in concretes and mortars containing silica fume as a supplementary cementitious material. The main aim of this project is to study the strength and the durability performance of EPS concretes. These mixes were designed by using the efficiency of silica fume at the different percentages. The resulting concretes were seen to have densities varying from 1500 to 2000 kg/m3, with the corresponding strengths varying from 10 to 21 MPa. The rate of strength gain for these concretes shows that an increase in the percentage of silica fume increases the 7-day strength. This was observed to be about 75%, 85%, and 95% of the corresponding 28-day strength at the silica fume replacement levels of 3%, 5%, and 9%, respectively. The results of absorption, at 30 min and the final absorption, show that the EPS mixes made with sand have lower levels of absorption compared to the mixes containing normal aggregates. Further, the absorption values were seen to be decreasing with increasing cementitious content. The performance of these concretes, in terms of their chloride permeability and corrosion resistance, even at the minimal silica fume content level was observed to be very good. © 2002 Published by Elsevier Seicence Ltd.