Options
CFD analysis of combustion and emission characteristics of biodiesel under conventional and late-injection based premixed combustion conditions
Date Issued
01-11-2023
Author(s)
Gowrishankar, Sudarshan
Krishnasamy, Anand
Abstract
The simultaneous reduction in NOx and smoke emissions can be achieved with biodiesel under a late-injection based low temperature combustion (LTC) strategy. However, this occurs at the expense of a substantial increase in unburned hydrocarbon (HC) and carbon monoxide (CO) emissions. It is worthwhile to understand the reasons behind the formation of these emissions, emphasizing comparison with conventional combustion, which is known to result in significantly low HC and CO emission levels, particularly with oxygenated biodiesel fuel. The present investigation attempts to examine the same with 3D CFD simulation. Experimental data were obtained from a light-duty diesel engine using biodiesel from non-edible Karanja oil. The unmodified engine with OEM low-pressure mechanical fuel injection system was utilized for conventional combustion operation. It is replaced with a modified common rail injection system for a late-injection-based LTC mode of operation. By combining retarded high-pressure injection with EGR, sufficient premixing was sustained to enable late injection-based premixed combustion (LI LTC). The combustion simulation was performed using CONVERGE CFD tool, utilizing a two-component surrogate of methyl butanoate (MB) and n-dodecane to represent biodiesel. A reduced chemical kinetic mechanism, developed and validated in an earlier investigation on biodiesel combustion, was utilized in the current study. The mechanism was solved using the SAGE Detailed CHEMKIN solver in CONVERGE. Validation was conducted at two engine operating conditions defining low and high loads for both combustion modes. The cylinder pressure and heat release rates were predicted with a maximum error of 1.5 and 13%, respectively. The validated CFD tool was employed to compare and analyze the equivalence ratio, in-cylinder gas temperatures, and HC and CO contours between conventional and LI LTC modes. Under LTC mode, the cylinder pressure and heat release rates were predicted with a maximum error of 10 and 15%, respectively. The comparison revealed fuel-rich regions concentrated near the bowl in conventional combustion, while the fuel was spread throughout the combustion chamber in LI LTC mode with over-rich and over-lean regions near the cylinder wall. The cylinder temperature is significantly higher for conventional combustion than LI LTC mode. The O and OH radical concentrations are higher for conventional combustion, corroborating with lower CO emissions, as they aid in CO oxidation. Fuel-rich regions contribute to increased CO emissions, whereas over-lean regions at a low-temperature result in high HC emissions, exhibited by the emission contours. Possible countermeasures to reduce high HC and CO emissions in LI LTC mode include maintaining higher coolant temperatures to enable HC and CO oxidation in the near-wall regions and fuel injection system modification to alter the air–fuel mixing.
Volume
351